EXPOSURE / 01
See the light.
Make the call.
Fast answers when you are standing next to the camera.
THE QUICK LOOK
Reference
Everything at a glance.
On a clean S-Log3 signal. Check the log waveform, not the monitoring LUT.
Sony's formula gives ~49 IRE at +1 stop. The earlier 48.5 IRE note is a useful field approximation.
Open up. Cut light. Know the trade.
| STOP | APERTURE | SHUTTER* | ND |
|---|
*Shutter values show a one-stop sequence at 24 fps, starting at 180° / 1⁄48 s. Rounded camera settings may vary.
ND in stops
Optical density = stops × 0.3. VND marks are approximate unless calibrated.
What the numbers mean
If fill hits both sides, bright-side : shadow-side = (key + fill) : fill.
ON-SET TOOLS
Interactive
Change a number. See the stop.
What changes if I…
Compare a base camera setup with the setup you are considering. Positive stops brighten the image.
Keep the aperture.
Meter the scene with no ND. Enter the f-stop the meter gives and the f-stop you want.
Assumes the same ISO and shutter angle for both readings. Confirm the final exposure on the camera.
Place gray. Place skin.
Set gray exposure first, then set where the skin reads relative to that gray card.
Skin has no universal IRE target. This shows the value for your chosen placement. Raising gray shifts the whole exposure; raising skin relative to gray changes subject placement.
See the contrast.
Meter key and fill separately at the subject, using the same ISO and shutter. Enter each light's f-stop reading.
Your starting points.
Save the base setup and S-Log3 placement above. Presets stay in this browser, including when offline.